CHECKLIST FOR NEC INPUT CARDS

CM Comments, up to 78 characters including blanks
CE End of comments, blank

   Following cards have up to 2 integers, up to 7 FP numbers

GA Tag#,#segs,Arc Rad,Start Angle,End Angle,Wire Rad (wire curve)
GE Ground Present (ends geometry input)
GH Tag#,#segs,Spacing,Length,XStart Rad,YStart Rad,XEnd rad,YEnd 
   Rad,Wire Rad (helix)
GF Print/no Print (read NGF file)
GM TagInc,#new,RotX,RotY,RotZ,MovX,MovY,MovZ,Tag (dupstructure)
GR TagInc,#new (generate cylinder from a face)
GS ,,Times Factor (Scale by factor) 
GW Tag#,#segs,X1,Y1,Z1,X2,Y2,Z2,Rad (straight wire)
GC ,,RatioLength,Rad1,Rad2 (Taper if GW Rad=0)
GX TagInc,Planes (Reflect structure per planes)
SP ,Shape,X,Y,Z,eaXY,aaX,Area (surface patch)
SC ,NewShape,X3,Y3,Z3,X4,Y4,Z4 (shape if SP>0)
SM X#,Y#,X1,Y1,Z1,X2,Y2,Z2 (Multipe Patches in X,Y)
SC ,,X3,Y3,Z3 (Required after SM)

    Following cards have up to 4 integers, up to 6 FP numbers

CP Tag1,Seg1,Tag2,Seg2 (max coupling named segs, up to 5)
EK Cancel (Extended TW kernel, ©1=cancel)
EN    (ends run)
EX Type, (voltage,current,external, place or angle)
FR TypeStep,#step,,Freq,Step (frequency, Mhz)
GD ,,,,K,Cond,DistTo2,Elev2 (additional ground zone)
GN Type,#Radials,,,K,Cond (first ground type)
KH ,,,,Dist  (interaction approx range)
LD Type,Tag,TagStaet,TagEnd,R,L,C (loads at segments)
NE Coord,N1,N2,N3,X,Y,Z,dX,dY,dZ (near field (or angle))
NH                 (same)
NT Tag1,Seg1,Tag2,Seg2,Real11,Imag11,R12,I12,R22,I22 (network)
NX     (new structure starts)
PQ Flag,SegsTag,Flag,Flag  (print wire charge)
PL File,Flag,Flag,Flag    (data Storage for plots)
PT Flag,SegsTag,Flag,Flag  (print currents)
RP Mode,#th,#ph,Th1,Ph1,dTh,dPh,Dist,Normal (Pattern out)
TL Tag1,Seg1,Tag2,Seg2,Zo,Len,Radm1,I1,R2,I2 (trans line)
WG     (write NGF file)
XQ Options